Installing The Handlebars (Fjr13Ae) - Yamaha FJR13AEV(C) Service Manual

Clutch master cylinder holder
bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
NOTE:
• Install the clutch master cylinder holder with
the "UP" mark facing up
• Align the mating surfaces of the clutch master
cylinder holder with the punch mark "a" on the
left handlebar.
• First, tighten the upper bolt, then the lower bolt.
11.Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-10.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
ET3P66031

INSTALLING THE HANDLEBARS (FJR13AE)

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Handlebar grip
• Grip end "1"
M MMM M MMM M M MMM M M MMM M
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
Recommended adhesive
Three Bond 1530
b. Slide the handlebar grip onto the left handle-
bar.
c. Wipe off any excess rubber adhesive with a
clean rag.
M MMM M M MMM M MMM
®
4-70
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
NOTE:
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
L LLL L LLL L L LLL L L LLL L
3. Install:
• Right handlebar switch "1"
NOTE:
Align the projection "a" on the right handlebar
switch with the hole "b" on the right handlebar.
4. Install:
• Left handlebar switch "1"
NOTE:
Align the projection "a" on the left handlebar
switch with the hole "b" on the left handlebar.
5. Install:
• Hand shift switch "1"
HANDLEBARS
L LLL L L LLL L LLL