JVC UX-G300B Service Manual page 18

3.2.7 Removing the feed motor
(See Fig.11 to 13)
• Remove the traverse mechanism.
(1) Remove the yellow wire from solder part q of the CD servo
board from upper side of traverse mechanism. (See Fig.11)
(2) Remove the white wire from solder part r of the CD servo
board. (See Fig.11)
(3) Remove the one screw G attaching the plate. (See Fig.12)
(4) Disengage the plate from fixing part s and take out the
plate. (See Fig.12)
(5) Remove the feed gear and take out the feed motor. (See
Fig13)
Reference:
When attaching the feed motor, the wire has to through the
part t of the traverse mechanism assembly. (See Fig.13)
CD servo board Traverse mechanism assembly
G
Fixing part s
Traverse mechanism assembly
1-18 (No.MB665<Rev.004>)
Yellow wire
White wire
Soldered part q
Soldered part r
Fig.11
Plate
Fig.12
Feed gear Feed motor
Traverse mechanism assembly
Fig.13
part t