Related Manuals for JVC LVT1364-002B
Summary of Contents for JVC LVT1364-002B
-
Page 1: Micro Component System
MICRO COMPONENT SYSTEM UX-G4 –Consists of CA-UXG4 and SP-UXG4 UX-G3 –Consists of CA-UXG3 and SP-UXG3 INSTRUCTIONS LVT1364-002B... - Page 2 IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.
-
Page 3: Safety Instructions
“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮... - Page 4 Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual About This Manual This manual is organized as follows: •...
-
Page 5: Table Of Contents
Contents Location of the Buttons and Controls ... 3 Main Unit ... 3 Remote Control ... 5 Getting Started ... 6 Unpacking ... 6 Connecting AM (MW) and FM Antennas ... 6 Connecting Speakers ... 6 Connecting Other Equipment ... 7 Putting the Batteries into the Remote Control ... -
Page 6: Location Of The Buttons And Controls
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Top view Front view COMPACT DIGITAL AUDIO D A I L Y T I M E R / S N O O Z E STANDBY VOLUME –... - Page 7 Display window DAILY 123 ALL GR. See pages in parentheses for details. Main unit 1 Disc cover (10) 2 ) OPEN (disc cover open) (10) 3 DAILY TIMER/SNOOZE button (22) 4 Remote sensor (5) 5 STANDBY lamp (8) (STANDBY/ON) button (8) 7 Source buttons •...
-
Page 8: Remote Control
Remote Control See pages in parentheses for details. STANDBY/ON DISPLAY FM MODE SLEEP CLOCK /TIMER CANCEL TAPE FM/AM RANDOM PROGRAM REPEAT RDS SEARCH PRESET GROUP DOWN PRESET GROUP SOUND/HBS BEAT CUT REV.MODE FADE MUTING R EMOTE CONTROL 1 STANDBY/ON 2 SLEEP button (23) 3 CLOCK/TIMER button (8, 21) 4 SET button (8, 15, 21, 22) 5 CANCEL button (21, 22) -
Page 9: Getting Started
Getting Started Unpacking After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM (MW) loop antenna (1) • Remote control (1) •... -
Page 10: Connecting Other Equipment
To remove the speaker grilles The speaker grilles are removable as the illustration below. Holes To remove the speaker grille, insert your fingers around the projection at the top of the speaker grille, then pull gently towards you while holding the side. Do the same for the rest of projections one at a time. -
Page 11: Common Operations
Common Operations Setting the Clock Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, “0:00” starts flashing on the display. You can set the clock when the unit is either turned on or in standby mode. -
Page 12: Selecting The Source
Selecting the Source To select the source, press CD 6, TAPE 2 3, FM/AM, or AUX. • When you select CD as the source, playback starts automatically. To operate the CD player, see pages 10 to 13. To operate the tape deck, see page 14. To operate the tuner (FM or AM (MW)), see pages 15 to 17. -
Page 13: Playing Back Discs
Playing Back Discs This unit has been designed to play back the following discs—CD, CD-R, and CD-RW. Only CDs bearing these marks can be used with this Systems. ReWritable Recordable You can play back the discs containing the tracks in music CD format or MP3 files in ISO 9660 format. -
Page 14: Basic Disc Operations
Tag To remove the disc, press ) OPEN on the unit, then take out the disc by holding it at the edges while pressing the unit’s pivot lightly. • If the disc cannot be read correctly (because it is scratched, for example) or an unreadable CD-R or CD-RW is inserted Playback will not start. -
Page 15: Repeating Tracks-Repeat Play
Press CD 3/8. The tracks are played in the order you have programed. When you finished programming the 60th track “FULL” will appear on the display. To stop playing, press 7. To check the program contents You can check the program contents by pressing PROGRAM repeatedly before or after playback. -
Page 16: Playing At Random-Random Play
Playing at Random—Random Play You can play the tracks at random. On the remote control ONLY: Press RANDOM. The RANDOM and indicators light up on the display. RANDOM To stop playing, press 7. To exit from Random Play, press RANDOM. The RANDOM and indicators go off. -
Page 17: Playing Back Tapes
Playing Back Tapes Playing Back a Tape You can play back type I tapes only. Press PUSH OPEN. The cassette holder opens. Put a cassette in with the exposed part of the tape down. Close the cassette holder gently. • When a tape is inside of the cassette holder, the tape direction indicator ( 3 ) lights up on the display. -
Page 18: Listening To Fm And Am (Mw) Broadcasts
Listening to FM and AM (MW) Broadcasts Tuning in to a Station Press FM/AM to select either “FM” or “AM (MW).” The unit automatically turns on and tunes in to the previously received station—either FM or AM (MW). • Each time you press the button, the band alternates between FM and AM (MW). -
Page 19: Tuning In To A Preset Station
Tuning in to a Preset Station On the remote control ONLY: Press FM/AM to select either “FM” or “AM (MW).” The unit automatically turns on and tunes in to the previously received station—either FM or AM (MW). • Each time you press the button, the band alternates between FM and AM (MW). -
Page 20: Searching For Programs By Pty Codes (Pty Search)
Searching for Programs by PTY Codes (PTY Search) One of the advantages of RDS is that you can locate a particular kind of program by specifying the PTY codes. • For details on the PTY codes, see “ ” on the right column. codes •... -
Page 21: Using An External Equipment
Using an External Equipment Listening to the External Equipment You can listen to the external equipment such as MD recorder, cassette deck, or other auxiliary. • First, make sure that the external equipment is properly connected to the unit. (See page 7.) Set the volume level to the minimum position. -
Page 22: Recording
Recording IMPORTANT: • It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable program and in any literary, dramatic, musical, or artistic embodied therein. -
Page 23: Recording Discs-Disc Synchronized Recording
Recording Discs —Disc Synchronized Recording You can start disc play and recording at the same time. On the unit ONLY: Put a recordable cassette in with the exposed part of the tape down. • See also page 14. Close the cassette holder gently. Press CD ‹/8 to select the CD player as the source. -
Page 24: Using The Timers
Using the Timers There are four timers available—Daily Timer, Recording Timer, Snooze Timer, and Sleep Timer. • Before using these timers, make sure the built-in clock is set correctly (see page 8). Using Daily Timer and Recording Timer You can set the timer whether the unit is on or off. How the Timer actually works When the on-time comes, the unit automatically turns on (the [timer] indicator flashes and continues flashing while the... -
Page 25: Using Snooze Timer
For the Recording Timer ONLY: Set the off-time you want the unit to turn off. (1) Press UP or DOWN to set the hour, then press SET. (2) Press UP or DOWN to set the minute, then press SET. If you want to change the time setting, press CANCEL. -
Page 26: Using Sleep Timer
Using Sleep Timer With Sleep Timer, you can fall asleep to your favorite music or radio program. • You can set Sleep Timer only when the unit is turned on. • You can also turn off the unit automatically by using Auto Standby. -
Page 27: Maintenance
Maintenance To get the best performance of the unit, keep your discs, tapes and mechanism clean. General notes In general, you will have the best performance by keeping your discs, tapes and the mechanism clean. • Store discs and tapes in their cases, and keep them in cabinets or on shelves. -
Page 28: Troubleshooting
Troubleshooting If you are having a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer for service. -
Page 29: Specifications
Specifications Amplifier Section Output Power: 25 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. (IEC268-3) Audio input sensitivity/Impedance (at 1 kHz) Speakers Impedance: Tuner FM tuning range: AM (MW) tuning range: 522 kHz – 1 629 kHz CD player Dynamic range: Signal-to-noise ratio:... - Page 30 0205NYMMDWORI © 2005 Victor Company of Japan,Limited...