Appendix C: Resetting The Digi One Configuration - GE iBox Installation And Maintenance Manual

GE Grid Solutions
Appendix C: Resetting the Digi One
Configuration
You can restore your Digi One configuration to the factory default configuration, as follows:
Procedure:
Step
Resetting the
1
Digi One
Configuration
2
3
4
5
GE Information
Turn off power to the Digi One.
With a pointed object, such as small screwdriver or the point of a
paperclip, press and hold the recessed RESET switch, located on the
same side of the Digi One as the Ethernet connector:
While holding down the RESET button, restore power to the Digi One.
Result: The Digi One DIAG LED displays a 1–5–1 pattern after about
20 seconds.
When the 1–5–1 LED pattern is complete, release the RESET button.
Result: The Digi One boots up and its configuration resets to default.
The user name resets to root and the password to dbps.
Reconfigure the unit by following the procedure outlined in
"Configuring the Ethernet Module" on page 109.
Installation and Maintenance Guide
Action
RESET Switch
994-0047-5.10-4
iBox/iBox Kit
153