Installer Settings - Vivint V-SH1 Setup Manual

Installer Settings

This section contains descriptions, default values, and notes about the Installer settings.
To access these settings from the control panel, go to:
Menu > Settings > Installer Toolbox > Installer
From the Installer screen, you can view and configure the following settings.
Installer Code (4 digits)
DEF AULT: 2203
The Installer Code is the code required to enter the Installer Toolbox.
The default for the Installer Code is 2203.
l
To change the Installer Code, enter a new 4- digit code.
l
Keep in mind the Installer Code must be unique from all of the other user PIN codes.
l
IMPORTANT: BE SURE TO WRITE DOWN THE NEW CODE!
Lock Installer Programming After 48 Hours
DEF AULT: Enabl ed
This setting is provided to prevent takeovers. The control panel can be set to limit an installer's access to system
settings after a period of 48 hours. The 48 hour lockout timer starts when the installer registers the system.
When disabled, this allows for unlimited full access to system configuration (no lockout).
To deny access to system configuration after 48 hours, set this option to enabled.
After the 48 hour lockout timer has locked out the system, the timer can be reset through the Vivint Platform
Admin Tool.
Panel Debug Mode
DEF AULT: Off
This option is dimmed or grayed out in a customer installation, which is expected and proper behavior, as it is
used for internal testing purposes only.
Reset To Factory Defaults Button
DEF AULT: Enabl ed
Use this setting to enable and disable the Reset to Factory Defaults button that is located inside the control panel.
This is the hard button labeled "RESET" on the circuit board inside the control panel.
Configure System Settings: Installer Settings
- 39 -