Assembling The Head And Foot Spring Sections - Invacare 5310IVC User Manual

4.4 Assembling the Head and Foot Spring
Sections
1. Remove the head spring section (5000 IVC) A of the
bed from the packing carton.
2. Place the head spring section on its side to your left so
the center mounting latches C are on the right.
3. Open the head spring section to a 45° to 90° angle to
support the spring section.
4. Remove the foot spring section B of the bed from the
packing carton.
5. Place the foot spring section on its side on your right
with the head spring pull tube E at the top of the
assembly. The center mounting rivets D should be on
the left.
For set-up purposes, the motors on the
semi-electric (5890IVC and 5891IVC) and full
electric (5490IVC and 5491IVC) foot springs as
well as the crank handles on the manual foot
springs (5770IVC) should be on your right.
1114836-H-05
6. Place the head and foot springs approximately 90° from
each other.
7. Hook the bottom head spring center mounting latch A
to the bottom foot spring center mounting rivet B.
8. Hook the top head spring center mounting latch A to
the top foot spring center mounting rivet B.
It may be necessary to lift the head spring
or foot spring slightly to secure the mounting
latches and rivets.
9. After head and foot springs are connected, push the
springs into a horizontal (straight) position while keeping
the springs on their sides.
Set-up
21