3.1.4 Removing the OPE board (See figure 10, figure 11,
figure 12, figure 13)
• Remove the plate R and plate F.
(1) Remove the four screws H attaching the OPE cover as-
sembly.
(2) Remove the two tabs and then remove the OPE cover as-
sembly.
(3) Disconnect the wire from connector
board.
CODEC Board
H
Tab
H
OPE Cover assembly
CN21
on the CODEC
CN21
H
Tab
H
OPE Cover assembly
Fig.10
Fig.11
(4) Remove the two screws J attaching the OPE board, and
then remove it.
OPE Board
Fig.12
NOTE:
When replacing the LCD, do not straighten the FPC that
was once bent. Repeating the bend and straighten oper-
ation may cause backlight failures.
Fig.13
J
LCD
Do not straighten the FPC
that was once bent.
(No.HC027<Rev.001>)1-7