This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
3.1
KA-MR100G
3.1.1 Removing the PS board (See figure 1, figure 2)
(1) Remove the four screws A attaching the plate R.
Plate R
(2) Remove the four screws B attaching the PS board.
(3) Disconnect the wires from each connector CN12,
the PS board.
CN13
CN12
PS Board
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY
A
A
Fig.1
CN13
B
B
Fig.2
SECTION 2
SECTION 3
3.1.2 Removing the 68PIN board, CODEC board, SxS board
(See figure 3, figure 4, figure 5, figure 6)
(1) Remove the four screws C attaching the plate F.
(2) Disconnect the wire from connector
board.
on
(3) Remove the two screws D attaching the 68PIN board, and
then remove it.
C
Plate F
C
Fig.3
CN6
on the 68PIN
CN6
68PIN Board
D
Fig.4
(No.HC027<Rev.001>)1-5