JVC XM-P55 Service Manual page 18

XM-P55
XM-PJ1
Removing the Front Cover Assembly
1. Remove the bottom cover assembly.
2. Remove the two C screws attaching the front cover
assembly, and remove the front cover assembly while
turning it in the direction of the arrow in the Fig.4.
Removing the Cabinet (See Fig.5 to 8)
1. Remove the bottom cover assembly.
2. Remove the front cover assembly.
3. Remove the screw D attaching the cabinet on the upper
side of the body.
4. Reverse the body and remove the two E screws attaching
the cabinet on the back of the body.
5. Release the two joints b on the flame assembly side of
the battery case in the direction of the arrow, and remove
the cabinet from the flame assembly.
6. Unsolder the two harnesses (one is orange, the other is
gray) connected to the main board. Disconnect the
battery connector B with the brown harness by pulling
upward.
CAUTION: When reassembling, attach the harnesses
with a double-sided tape to the part c on the
inside of the cabinet (See Fig.8).
Cabinet
Main board
Fig. 7
2-16
(See Fig.4)
Flame assembly
Unsoldering
Battery connector B
C
Cabinet
Joints b
Part c
C
Front cover assembly
Fig. 4
D
Fig. 5
Main board
E
Cabinet Fig. 6
Cabinet
Main board
Fig. 8