Technical Data - DeLonghi ECP35.31 Instructions For Use Manual

Cleaning the coffee filters
l
Clean the coffee filters regularly by rinsing under running water.
e
Make sure the holes are not blocked. If necessary, clean with a
t
pin (fig. 27).
0
Cleaning the boiler outlet
About every 300 coffees, the boiler outlet must be cleaned as
follows:
1. Make sure the appliance is not hot and that it is unplugged
from the mains;
2. Using a screwdriver, unscrew the screw fixing the espresso
boiler outlet (fig. 28);
3. Remove the boiler outlet;
4. Clean the boiler with a damp cloth (fig. 28);
5. Clean the outlet thoroughly in hot water using a brush.
Make sure the holes are not blocked. If necessary, clean
with a pin.
-
6. Rinse under running water, rubbing all the time.
7. Replace the boiler outlet, making sure the gasket is cor-
rectly positioned.
Failure to clean as described above invalidates the guarantee.
Cleaning the water tank
e
1. Clean the water tank regularly (about once a month) and
whenever you replace the water softener filter (C7, *if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the filter (*if present) and rinse with running
water.
-
3. Replace the filter (*if provided), fill the tank with fresh
water and replace the tank.
4. (Models with water softener filter only) Deliver about 100
ml of water.
DESCALING
e
You are recommended to descale the coffee maker about every
200 coffees.
We recommend using commercially available De'Longhi (C6*)
r
descaler.
Proceed as follows:
1. Fill the tank with the descaler solution, obtained by dilut-
ing the descaler with water following the instructions on
the pack.
,
2. Press the ON/OFF button.
-
3. Make sure the filter holder is not attached and place a re-
cipient under the cappuccino maker.
4. Wait until the OK light comes on.
5. Turn the mode selector dial to the
deliver about 1/4 of the solution in the tank. At intervals,
turn the steam dial to the
water from the cappuccino maker. Then interrupt delivery
by turning the mode selector dial to the l position and
leave the solution to work for about 5 minutes.
6. Repeat point 5 another 3 times, until the tank is empty.
7. To eliminate residues of descaler solution, rinse the tank
well and fill it with clean water (without descaler).
8. Turn the selector to the
water until the tank is empty.
9. Repeat points 7 and 8.

TECHNICAL DATA

Mains voltage:
Absorbed power:
Size LxDxH:
Pressure:
Water tank capacity:
Power cord length:
Weight:
The appliance complies with the following EC
directives:
• Stand-by European Regulation 1275/2008 and subsequent
amendments;
• Materials and accessories coming into contact with food
conform to European regulation 1935/2004.
DISPOSAL
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
position and
11
position to deliver
position and deliver
220-240V ˜ 50/60Hz
1100W
185x244(329)x305 mm
15 bar
1.1 l
1300 mm
3,8 kg