Table of Contents
Advertisement
TIG / S tick Welding
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: Remove the protective foam and cardboard from the Welder before setup. Place the Welder on a level
surface that can bear its weight near the work area. Leave space around the Welder for proper air flow.
TIg Setup
connect cables
Foot pedal
(sold separately)
Shielding
gas Hose
TIg Torch
(sold separately)
1. Plug Ground Clamp Cable into Positive Socket.
Twist clockwise all the way to lock in place.
2. Plug TIG Torch Cable (TIG Torch sold
separately) into Negative Socket. Twist
clockwise all the way to lock in place.
Page 24
TO pREVENT SERIOUS INJURy FROM AccIdENTAL OpERATION:
Turn the power Switch off and unplug the Welder before setup.
Foot pedal Socket
(inside Welder)
Foot pedal
cable
ground
clamp
For technical questions, please call 1-888-380-0318.
ground clamp cable
in positive Socket
3. Insert the Foot Pedal Cable (Foot Pedal
sold separately) through hole on Welder
front and connect to the Foot Pedal
Socket inside the machine. Secure by
turning collar clockwise until tight.
4. For connecting Shielding Gas Hose, refer to
Connect Shielding Gas section on next page.
TIg Torch
cable in
Negative
Socket
Item 63621
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OMNIPRO 220 and is the answer not in the manual?
Questions and answers
Inside the omnipro 220 where does the wire feed connector conect
The wire feed connector connects to the socket on the Wire Feed mechanism inside the Vulcan-Hart OMNIPRO 220.
This answer is automatically generated
cannot get wire auto feed to work
If the wire does not feed properly and the spool is stationary, turn off and unplug the welder. Slightly tighten the feed tensioner clockwise before retrying. To check the wire’s drive tension, feed the wire against a piece of wood from 2 to 3 inches away. If the wire stops instead of bending, unplug the welder, slightly tighten the feed tensioner clockwise, and try again. If the wire bends from the feed pressure, the tension is set properly. If needed, push the wire liner back into the gun.
This answer is automatically generated
My wire speed knob stopped working. I can't change the speed. What should I do or replace
How can I purchase internal parts ?
Some internal parts of the Vulcan-Hart OMNIPRO 220 are listed for illustration purposes only and are not available individually as replacement parts. There is no information provided on purchasing internal parts.
This answer is automatically generated