Advertisement
Wingnut
Spacer
Spindle
2 lb
Wire
Spool
Brake
Pad
2 lb Spool Loading
Adapter and knob required for 10-12 lb spool
WARNING
To prevent serious
injury, read
manual warnings
and instructions
before use.
WARNING
To prevent fire
and serious
injury, keep torch
and wire clear of
grounded objects
while welder
plugged in.
HOLD
GUN
CLEAR
BASIC WELDING INSTRUCTIONS AND WELDING TIPS ARE IN MANUAL.
Welder
Contact
Tip
Nozzle
clockwise
Feed
Mechanism
feed
guides
welding
wire
Wire Spool
wood
block
Advertisement
Table of Contents
Related Manuals for Vulcan-Hart Omnipro 220
Summary of Contents for Vulcan-Hart Omnipro 220
- Page 1 Feed Wingnut Mechanism Spacer Spindle 2 lb Wire feed Spool guides Welder Brake welding wire 2 lb Spool Loading Wire Spool Adapter and knob required for 10-12 lb spool WARNING To prevent serious Contact injury, read manual warnings and instructions Nozzle before use.
- Page 2 BASIC WELDING INSTRUCTIONS AND WELDING TIPS ARE IN MANUAL.
Need help?
Do you have a question about the Omnipro 220 and is the answer not in the manual?
Questions and answers
What size wire and breaker is used on this welder to hook up
@Mark Did you find an answer? I switched out the original 20 Amp 250 Volt plug that was on the end of the factory power cord for a 30 Amp 250 Volt Twist Lock Plug that matched the receptacle on the Harbor Freight 9500 Watt Inverteer generator. And I wired in a 30 Amp 250 Volt Twist Lock Receptacle in my garage/shop. I was able to get both at Home Depot. I was not able to find a receptacle to fit the factory plug is why I did this. And, I wanted to be able to weld at home as well as on the road with the generator without using a conversion cable.