Changing The Addresses And Options Individually - Samsung AC026MNJDKH/EU Service Manual

• Even if you set the Use of drain pump (SEG8) option to 0, it is automatically set to 2 (the drain pump is used with 3 minute delay).
• If you set the Maximum filter usage time (SEG18) option to a value other than 2 and 6, it is automatically set to 2 (1000 hours).
• If you set the Individual control with remote control (SEG20) option to a value other than 0 to 4, it is automatically set to 0
(Indoor 1).
• Default value of Heating setting compensation (SEG21) is 5°C for 360 cassette model.
* Level control: The centralized controller can limit the functions and inputs of connected products with this function
enabled. (Example: Operation mode limit (Cooling only/Heating only/No limitation), Heating
temperature upper limit, Cooling temperature lower limit)
To enable 'Level control' when applying the DPM with the centralized controller, appoint the master (Set
'Use of external control [SEG14] option to 4 or higher).
Example: When installing DPM (1 Outdoor unit with 4 indoor units)
Condition
External control Level control
Default
Disuse
Use (Indoor 3)
Use (Indoor 4)

4-1-4 Changing the addresses and options individually

When you want to change the value of a specific option, refer to the following table and follow the steps in Common
steps for setting the addresses and options on page <?>.
Option SEG1
Function Page
Indication Details
Indication
and details
0
Example: Changing the Buzzer control (SEG17) option of the installation options to 1 disuse.
Option SEG1
Function Page
Indication 0
Samsung Electronics
Indoor 1
Use 4
Disuse Not set (0)
Use Not set (0)
SEG2
Option mode to
Mode
Indication Details Indication
Option
D
type
SEG2
Option mode to
Mode
D
SEG14 Setting
Indoor 2 Indoor 3
Not set (0)
Not set (0) Not set (0)
Not set (0) 1~3
Not set (0) Not set (0)
SEG3 SEG4
Tens position
of the option
change
number
Details Indication Details
Tens
0 to F position 0 to 9
value
SEG3 SEG4
Tens position
of the option
change
number
2 1
Result
Indoor 4
Slave (All)
Master (Indoor 1), Slave
Not set (0)
(Indoor 2,3,4)
Not set (0) Slave (All)
Master (Indoor 4), Slave
5~7
(Indoor 1,2,3)
SEG5
Units position
of the option New value
number
Indication Details Indication
Units
New
position 0 to 9
value
value
SEG5
Units position
of the option New value
number
7
SEG6
Details
0 to F
SEG6
1
4-9