Warning
Read as follows
Problem
Image is not or incorrectly
displayed
Philips Multimedia Projector
7.Troubleshooting
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to correct a problem by following these hints, consult your dealer or service
center.
Under no circumstances should you try to repair the projector yourself as this could void your
warranty.
–
Possible cause
•
Solution
General
–
Mains lead is not correctly connected.
•
Check the mains lead connection.
–
Lamp holder cover is not closed correctly or the lamp holder is damaged.
•
Check cover for proper closure (see 'Lamp replacement' under 'Maintenance').
–
Signal cable not correctly connected.
•
Check signal cable connection.
–
The projector is in Off position.
•
Press the Standby button to turn the projector on.
In Video series mode
–
Keystoning is applied on a high resolution component signal.
•
Decrease keystoning until the image is correctly displayed.
For this use the 'Keystone' option in the 'Setup' menu.
In Data mode
--
Partial, scrolling or incorrectly displayed image.
•
Use the 'Auto Sync' option in the 'Picture' menu.
–
Input resolution is too high (and keystoning is applied).
•
If you wish to keep the keystone correction, decrease the input resolution until the image is
correctly displayed.
For this, refer to the User Guide or support information of the computer.
•
If you wish to keep the input resolution as it is, decrease keystoning until the image is
correctly displayed. For this, use 'Keystone correction' option in the 'Settings' menu.
–
Input resolution is too high (and no keystoning is applied).
•
Decrease the input resolution until the image is correctly displayed.
For this, refer to the User Guide or support information of the computer.
34
English User guide bCool SV1
>