Uploading A New Firmware Version - Motorola PTP 250 User Manual

PTP 250 User Guide

Uploading a new firmware version

To upload a new firmware version, proceed as follows:
1
Save the pre-upgrade system configuration as described in
configuration
2
Go to
updates. Download and save the required firmware image (for example
04-01.bin
3 Select menu option Firmware Update. The Firmware Update page is displayed
(Figure
4
Select the Method. The default is HTTP.
If FTP or TFTP is selected, additional attributes are displayed and must be
completed.
5 Select Browse. Navigate to the folder containing the downloaded firmware
image and select Open.
6
Select Start Firmware Upload and Yes to confirm. The upload progress is
displayed. On completion, the Upload Successful page is displayed
To ensure that only authorized Motorola firmware is installed, the unit checks the
image for a DSA signature. If the DSA signature is missing or incorrect, an error
message is displayed and the upload fails.
7
Select Apply and Reboot.
8
The reboot process will take up to 120 seconds. During this time it will not be
possible to communicate with the unit. After the reboot, check that the required
firmware image is loaded and
9
Save the post-upgrade system configuration as described in
configuration
phn-2182_003v004 (Oct 2011)
on page 6-35.
http://www.motorola.com/ptp/support
).
6-11).
on page 6-35.
and find Point-to-Point software
running.
UNDER DEVELOPMENT
Upgrading firmware version
Saving the system
PTP250-
(Figure 6-12).
Saving the system
6-11