Preparing The Poe Power Supply To Network Equipment Cable - Motorola PTP 250 User Manual

Installing the PoE power supply

Preparing the PoE power supply to network equipment cable

Prepare the CAT5e cable that will connect the PoE power supply to the network
equipment. This cable must meet the following requirements:
•
Use either foil screen (FTP) or braided screen (STP) cable.
•
Use screened RJ45 connectors with metal shells at both ends.
•
Ensure there is a continuous electrical connection between both screened connectors.
The connected network equipment must feature screened RJ45 connectors and must be
connected to ground, otherwise the PoE power supply will not be grounded.
The PoE power supply is not normally connected to the network equipment until antenna
alignment is complete. See
5-32
Connecting to the network
UNDER DEVELOPMENT
Chapter 5: Installation
on page 6-34.
phn-2182_003v004 (Oct 2011)