MECHANICAL INSTALLATION
2–6
Panel mounting with depth reducing collar:
1.
Mount the collar of required depth (1.375" or 3") to the unit (captive or non-drawout)
using 4 screws (see above).
2.
Mount the combination of unit and collar to the panel using 4 screws as shown above.
Figure 2-7: Mounting tabs (optional)
1.
From the front of the panel, slide the empty case into the cutout until the bottom tab
clicks into place (see above).
2.
From the rear of the panel screw the case into the panel at the 8 screw positions
shown above.
3.
If added security is required, bend the retaining "V"tabs outward, to about 90°. These
tabs are located on the sides of the case and appear as shown above.
The relay can now be inserted and can be panel wired.
"V" TABS
BOTTOM TAB
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 2: INSTALLATION