Yamaha CL5 Reference Manual page 160

◆ HA display
This shows the HA settings of the I/O device. Press this area to open the I/O DEVICE HA
window, in which you can make detailed head amp settings.
7
6
5
8
If you press the [SEL] key of an input channel, the corresponding port will light. (It does not
light for external CL series consoles.)
5 Analog GAIN knob
Indicates the analog gain setting. This screen is only for display; the value cannot be
edited.
6
+48V indicator
Indicates the phantom power (+48V) on/off status for each port.
7
OVER indicator
Warns you when the input signal is clipping.
8
HPF indicator
Indicates the high-pass filter on or off status for each port.
◆ INPUT display
This shows the input settings of I/O devices not assigned to REMOTE HA ASSIGN.
If you press the [SEL] key of an input channel, the corresponding port will light. (It does not
light for external CL series consoles.)
◆ OUTPUT display
This shows the output settings of the I/O device. Press here to access the OUTPUT PATCH
window, where you can make output port settings for the I/O device.
If you press the [SEL] key of an output channel, the corresponding port will light. (It does not
light for external CL series consoles.)
◆ RMio64-D display
Displays the RMio64-D panel. You can press the buttons to change settings.
1 2 3 4
6 7
1 MADI SRC ON indicator
MADI SRC ON button
Switches the SRC (Sampling Rate Converter) on and off.
2 MADI SRC WCLK IN indicator
MADI SRC WCLK IN button
Use this button to select whether to use (indicator on) or not use (indicator off) the word
clock input from the MADI WCLK IN FOR SRC jack on the rear panel of the RMio64-D
as a standard clock for SRC.
3
MADI INPUT RATE Fs 44.1kHz indicator
MADI INPUT RATE Fs 48kHz indicator
Automatically detect and indicate whether the MADI input signal is 44.1 kHz or 48 kHz.
Both indicators remain off if there is no valid MADI input signal.
4
MADI INPUT RATE 1Fs indicator
MADI INPUT RATE 2Fs indicator
MADI INPUT RATE 4Fs indicator
MADI INPUT RATE 1Fs/2Fs/4Fs button
Select either 1Fs (1x), 2Fs (2x), or 4Fs (4x), based on the MADI input frequency. For
example, if the MADI input signal is 192 kHz (4x 48 kHz), confirm that the MADI INPUT
RATE Fs 48kHz indicator is on and then select "4Fs".
NOTE
When "2Fs" is selected, the unit automatically detects the frame frequency (48 kHz/96 kHz) of
the MADI input signal.
157
I/O devices and external head amps
5
9
8
Reference Manual