Shaped Video Settings - Sony DVS-9000 User Manual

Shaped Video Settings

For each of the front and back sides of the image, specifies whether to handle
input video from the switcher as shaped video (key processed signals).
Note
The shaped video function is valid when using an SDI interface.
When using the BKDS-9470, since the input video signal to the first channel is
always set to the key processed signal on the switcher, the shaped video setting
is always on. For the second and third channel signals, this may also be turned
off.
Switching shaped video on or off
1
2
About on and off for shaped video input (Front Input/Back Input)
Switch shaped video on and off according to the input video signals.
For example, switch the shaped video input on when the input signal is a key
processed image such as computer graphics.
Switch the shaped video input off when the input signal is not key processed,
for example when a video signal taken with a camera is cut out with a title or
other key signal.
About on and off for shaped video output
Switch the shaped video output on and off to match the on and off state of the
switcher clean video mode.
638
DME Special Effect Operations
signals. If they are the back side, you can select the back signals. Video and
key signals are selected with the cross-point control blocks of each M/E
bank or the PGM/PST bank.
In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'
The Video/Key menu appears.
In the <Shaped Video> group, press each of the following buttons to
switch it on or off.
Front Input: When this is on, the front image of the input video signal is
treated as shaped video.
Back Input: When this is on, the back image of the input video signal is
treated as shaped video.
Output: When this is on, the output video signal is treated as shaped video.