Advertisement
11.When WindowsNT has restarted, click "Start".
From Programs in the Start Menu, click "Administrative
Tools" p "Windows NT Diagnostics". The program
starts up.
12.The Windows NT Diagnostics Program window appears.
Click the "Resources" label. The resource list shown
below appears (not in the same layout).
Note: "DVRNTDRV" indicates the TARGA2000DV board.
Check which number is used for the IRQ. After
checking, lick
OK
to close the window.
13.Change the display driver.
1)Open the "Control Panel" and double-click "Display".
Settings
2)Select
from "Display Properties" and click
.
3)Click
Change
in "Display Type".
4)Click
in "Display Modification".
Hard Disk
5)The directory of the display driver is to be opened, so
enter "c:\TARGA2KVD\WINNT\Display" and click
7)The message "The drivers were successfully installed"
appears. Click
8)Click
Close
in "Display Types".
9)Click
in "Screen Properties".
Close
10)The message "You must restart your computer..."
appears. Click
11)WindowsNT starts up. When the Control Plane opens,
close it.
When the message "A new graphics driver has been
installed" appears, click
12)Click and drag the
area in "Screen Properties" to adjust it for the resolution
of 1152 x 870 pixels. Here, confirm that the font size is
"Small Fonts", and that the Refresh Frequency is 75 Hz.
Test
13)Click
, and click
test screen appears.
14)If the test screen is displayed correctly, click
OK
15)Click
screen. The resolution will change.
Note: Be sure to modify the display and test it. Otherwise,
the display will not be correct.
7
OK
.
OK
.
OK
.
mark on the frame of the desktop
OK
to enter test mode. The
in "Display Properties" to close this
.
OK
Yes
.
Advertisement
