Advertisement
Installing the SCSI board
1. Remove the cover for the PC slot (the white connector on
the motherboard) that is adjacent to the slot where the
TARGA2000DV board is plugged in (on the side away
from the CPU).
2. Carefully remove the SCSI board from its anti-static
protective pack. If you need to set the board down, place
it on top of this pack.
3. Plug the SCSI board into the PCI slot adjacent to the
TARGA2000DV board on the side away from the CPU,
and secure the cover in place with the screws.
4. Store the screws and cover that were removed in a safe
place.
5. For details on the cable connections, refer to the fard disk
setup procedure. (Do not fail to connect the cables.)
6. Turn on the power and start up WindowsNT.
7. Open the Control Panel and start up WindowsNT.
8. Select "Driver" and click
9. The manufacturer and the SCSI adapter list appear.
Select "Adaptec" for the manufacturer, and "AHA-
294x/AHA-394x or AIC-78xx PCI SCSI controller" for the
OK
adapter, and click
Here, the WindowsNT CD-ROM is required, so load it and
click
OK
.
The "Windows NT CD-ROM" window opens. This is not
needed, so click the
on the upper-right of the window to
X
close it.
10.Specify the directory of the driver. For example, if the
CD-ROM drive is drive E, enter E:\i386, and click
11.When installation is ended, the message "You must
restart your computer..." appears. Click
Add
.
.
OK
.
12.When WindowsNT has restarted, click "Start".
From Programs in the Start Menu, click "Administrative
Tools" p "WindowsNT Diagnostics". The program
starts up.
13.The WindowsNT Diagnostics Program window appears.
Click the "Resources" label. The resource list appears.
"aic78xx" indicates the SCSI board. Check which number
is used for the IRQ.
"aic78x" is displayed twice. Both numbers might be the
same or they might not; it does not matter in either case.
After checking, click
OK
.
8
OK
to close the window.
Advertisement
