Re-Pairing Remote Control Unit To Another Iq3 - Foxtel iQ3 Domestic Installation Manual

2. The Remote Control is then held to the front of the iQ3 until the proximity sensor
lights up.
The iQ3 is now placed into pairing mode.
3. Now press any button on the Remote Control.
The Remote Control's light will flash blue then stop once it detects the iQ3.
4. The iQ3's front light flashes red once it has found the Remote Control and will
stop flashing once pairing is complete.
5. Now point the Remote Control towards the iQ3 and press any button to confirm
that it's operational.
Notes:

The iQ3 Remote Control will not work on any other Foxtel STU.

Legacy iQ Remote Controls will work on an iQ3 for available button functions mapped to that
Remote Control.

7.6.1 Re-pairing Remote Control Unit to another iQ3

If the Remote Control needs to be re-paired to another iQ3, follow the steps below.
 Locate the re-pair button inside the battery cover
 Press the re-pair button which will clear the existing pairing
 Then follow the pairing process again.
Re-pair button
Issue 5.3.1 23/03/2015
© 2015
Controlled Document – No Unauthorised Copying
Chapter 7A iQ3 Interconnection Methods
Page 12 of 62