Radf Opening/Closing Switch Adjustment - Toshiba e-STUDIO6520C Service Handbook

3.8.7

RADF opening/closing switch adjustment

Adjust the bracket position so that the sensor is turned ON when the height "J" becomes 145 mm or
less (within the empty weight falling limit).
(1) Take off the RADF rear cover.
Service Manual "16.5.3 RADF rear cover"
(2) Loosen the fixing screw of the bracket. Slide
the bracket vertically using the scale as a
guide to adjust the position where the switch
is turned ON.
(3) Tighten the fixing screw of the bracket. Install
the RADF rear cover.
e-STUDIO5520C/6520C/6530C
ADJUSTMENT
Fig. 3-67
Scale
Screw
Bracket
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 84
Fig. 3-68