Table of Contents
Advertisement
SELF-CLEAN OVENS
CAUTION
OVEN RACKS, AND UTENSILS.
essential for a good seal. Care should be taken not to
rub, damage, or move the gasket.
cleaner or oven liner protective coating of any kind
should be used in or around any part of the oven.
of birds is extremely sensitive to the fumes released
during an oven self-clean cycle. Fumes may be
harmful or fatal to birds. Move birds to a well-ventilated
room.
These models have Model/Serial Number labels and Tech Sheets located as shown below.
Model and Serial
Model & Serial
Number Location
Number Location
– The door gasket is
– No commercial oven
– The health
Tech Sheet
Location
7
– In the event the self-clean
mode "F" code goes on or three long beeps sound,
the oven is malfunctioning in the self-clean mode.
Turn off or disconnect appliance from electrical and
gas supplies and have the appliance serviced by a
licensed technician.
steam escape before you remove or replace food in
the oven.
Buildup of pressure may cause container to burst and
vent is located above the left-rear surface unit. This
area could become hot during oven use. Never block
this vent and never place plastic or heat-sensitive
items near the vent.
racks in the desired location while the oven is cool. If
a rack must be moved while the oven is hot, do not
let the pot holder contact a hot oven burner or oven
bottom.
IMPORTANT
DO NOT REMOVE ENVELOPE
OR DISCARD CONTENTS
REPLACE CONTENTS IN ENVELOPE
– Let hot air or
–
– The oven
– Always place oven
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the NX58H9500WS/AA and is the answer not in the manual?
Questions and answers
Model # NX58H9500WS - Gas stove ( Propane) appro 5 years old. Stove top lights on all burners. Oven - Bake- looks like it is going to light but never does. Just sits at 175. ideas to check?
1. Check the Bake Igniter – Ensure the bake igniter below the oven floor is glowing when the bake function is on. If it does not glow, it may be faulty and need replacement.
2. Test the Temperature Sensor – Confirm that the oven temperature sensor has proper continuity. If defective, replace it.
3. Inspect the Control Panel and PCB – Verify that the bake, broil, and control relays on the PCB are functioning correctly. Ensure all harness connections are secure. If needed, replace the PCB.
4. Check the Gas Valve – If the igniter glows but the oven does not heat, the gas valve may not be opening properly. A faulty valve should be replaced.
5. Examine Wiring and Harnesses – Look for any loose or damaged wiring connections between the control board, igniter, and gas valve.
6. Test the Broil Function – If the broiler works but the bake function does not, this can indicate an issue with the bake igniter or control board.
If these steps do not resolve the issue, replacing the bake igniter or control board may be necessary.
This answer is automatically generated
On back of control panel display has 2 wire harnesses. One harness has only 2 wires a black and white. They came out of plug while removing. Could you please give me location of these 2 wires in the plug. Plug has 8 spaces. I would greatly appreciate this.