Regal 23 OBX Owner's Manual page 197

CHAPTER 7
3. Wedge a 2 x 4 between the skeg and the propeller. Then use a deep
socket and ratchet to remove the propeller nut.
4. Next, remove the washer and spacer. Remove the propeller. Remove
thrust washer and see note below.
Note: Check the propshaft seal behind the propeller for fi sh line and
debris that could cut the propshaft seal.
Installing propeller- Before installing parts back on to the propshaft
make sure you lubricate the propshaft with the recommended lube.
1. Install the thrust washer on the propshaft fi rst as indicated in the
illlustration above. Then install the propeller.
2. Align the spacer protrusions with the cutouts of the propeller.
7-12
Removing the propeller- Before
removing the propeller make sure
the remote control is in neutral and
the ignition keys are removed to
prevent the outboard engine starting
and possibly causing bodily injury.
Always wear gloves when removing
or installing propellers since the
component blades are very sharlp.
1. Use pliers to straighten the cotter
key which will permit it to be pulled
through the propshaft.
2. Do not use your hand to hold the
propeller while removing the nut.