Philips DreamStation Go User Manual page 52

E T
missions EsT
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
Flicker emissions
IEC 61000-3-3
Emission of Radio
Frequency Energy
RTCA/DO-160G Section
21
Guidance and Manufacturer's Declaration - Electromagnetic Immunity – This device is
intended for use in the electromagnetic environment specified below. The user of this
device should make sure it is used in such an environment.
i T
mmuniTy EsT
Electrostatic
Discharge (ESD)
IEC 61000-4-2
Electrical fast
Transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
C
omplianCE
Group 1
Class B
Class A
Complies
Category M
iEC 60601 T
EsT
l
EvEl
±8 kV contact
±15 kV air
±2 kV for power
supply lines
±1 kV for input-
output lines
±1 kV differential
mode
±2 kV common
mode
E E
lECTromagnETiC
The device uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference
in nearby electronic equipment.
The device is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network.
This device is suitable for use onboard
commercial airplanes inside passenger cabin.
C E
omplianCE
l g
EvEl
±8 kV contact Floors should be wood,
concrete or ceramic tile. If floors
±15 kV air are covered with synthetic
material, the relative humidity
should be at least 30%.
±2 kV for supply Mains power quality should
mains be that of a typical home or
hospital environment.
±1 kV for input/
output lines
±1 kV Mains power quality should
differential be that of a typical home or
mode hospital environment.
±2 kV for
common mode
10. Additional Notes
- g
nvironmEnT uidanCE
E
lECTromagnETiC nvironmEnT
uidanCE
-
49