Deleting An Event - Sony MVS-8000X SystemMVS-7000X System User Manual

2
If required, press the [AUTO INS] button in the
keyframe control block to toggle the auto insert mode
on or off.
3
Create the event.
• When auto insert mode (see page 500) is on, the
event is automatically added to the macro.
• When auto insert mode is off, proceed to step 4.
4
When auto insert mode is off, press the [INS] button in
the keyframe control block.
5
Repeat steps 2 and 3 to insert the required events in the
macro.
Modifying a single event
1
Specify the edit point (see page 501).
2
If the [AUTO INS] button is lit, press it to turn off the
insert mode.
3
Create the event.
4
Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
1
Carry out steps 1 to 3 of the procedure in "Modifying
a single event" (the previous item).
2
Press the [FROM TO] button in the keyframe control
block, turning it on.
The numeric display in the numeric keypad control
block shows the current event number and the
indication "TO."
3
To set the start of the range to other than the current
event number, press the [CLR/AUTO TRANS] button
in the numeric keypad control block, then enter the
desired event number with the numeric keypad and
press the [ENTER] button (this operation is not
required when using the current event number).
4
Enter the event number for the end of the range and
press the [ENTER] button.
5
Press the [MOD] button in the keyframe control block.
Modifying all events at the same time
1
Carry out steps 1 to 3 of the procedure in "Modifying
a single event" (page 502).
502
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
2
Press the [ALL] button in the keyframe control block,
turning it on.
3
Press the [MOD] button.

Deleting an event

1
Specify the edit point (see page 501).
2
To delete multiple events simultaneously, carry out
either of the following operations (this operation is not
required to delete the event at the edit point only).
• To specify a range to be deleted, press the [FROM
TO] button in the keyframe control block, then enter
the event numbers from the numeric keypad control
block.
• To delete all events within this macro, press the
[ALL] button, turning it on.
3
Press the [DEL] button.
Moving events
1
Specify the edit point for the start of the range to be
moved (see page 501).
2
To move multiple events simultaneously, press the
[FROM TO] button in the keyframe control block,
then specify the range in the numeric keypad control
block.
3
Press the [DEL] button.
This temporarily deletes the specified events from the
macro, and copies them to the paste buffer.
4
Move to the edit point which is the destination within
the macro to which you want to move the events.
5
To paste the contents of the paste buffer after the edit
point, press the [PASTE] button in the keyframe
control block.
To paste before the edit point, hold down the [SHIFT]
button in the keyframe control block and press the
[PASTE] button.
This pastes the events from the paste buffer.
Copying events
1
Specify the edit point for the start of the range to be
copied.
2
To copy multiple events simultaneously, press the
[FROM TO] button or [ALL] button in the keyframe