Operation; Initial Use; Preparations To Be One Prior To The Initial Use; Installatıon Guıdelınes - Beko BSS-2201 TT User Manual

3

Operation

3.1 Initial use

1. Remove all the packaging and label materials
and dispose of them pursuant to the local re-
gulations in force.
2. Clean the appliance before the initial use (see
"Cleaning and maintenance" section).
3. Make sure that the appliance is placed on a
balanced, flat, clean, dry and non slip surface.
3.1.1 Preparations to be done prior to
the initial use
1. Before connecting the appliance to the power
source. Let it stand upright for approximately
2 hours. This will reduce the possibility of
a malfunction in the cooling system from
handling during transportation.
2. Check and make sure the backside hot water
drainage hole cap is not leaked or broken.
3. The water dispenser is pre-cleaned at the
factory but the reservoir and water lines must
be flushed with fresh water before use as
follows:
4. Keep the unit unplugged.
5. Fill water tank with tap water full to capacity.
Wait for 5 minutes until water settles.
6. Push the hot water faucet until water comes
out, then stop the faucet.
7. Plug the dispenser into the electrical outlet.
We are ready to complete the first cycle.
In order to do that, wait for the hot water
to reach temperature in approximately 10
minutes, and then wait for the cold water
to reach temperature in other 40 minutes
approximately.
8. Unplug the dispenser from the electrical outlet.
Proceed to drain the water from the faucets
one at a time until no more water remains.
(Note: To facilitate this operation, use a large
container).
9. Then, drain any water left in the tanks by
opening the backside hot water drainage hole
cap, until all water drains completely. After
that, screw up the cap tightly.
10.Put the bottled purified or other dean water
on the top cover one minute.
8 / 11 EN
11. Push water faucet buttons to insure water
flows from both faucets.
12 .Plug dispenser again into the electrical
outlet.
13. Now you are ready to use your water
dispenser.
Your water dispenser has been
cleaned and sanitized before
leaving the factory, but in case
C a taste problem develops, place
two tablespoons of baking soda
and add tap water. Fill water
tank again and repeat basic op-
erations, except turn hot water
function "OFF" to avoid leaving
residues in hot water tank.
3.1.2 Installatıon guıdelınes
1. Remove the exterior and interior packing.
2. Place your appliance on a floor that is strong
enough to support the dispenser when it is
fully loaded. The unit is provided with four
plastic feet. If it does not sit level on the floor,
adjust the front feet to level the unit well to the
floor.
3. Locate the appliance away from direct
sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient
temperatures may also cause the appliance
not to perform properly.
4. Allow 2 inches of space between the water
dispenser and the wall, which allows for
proper air circulation to cool the compressor.
5. Plug the appliance into an exclusive properly
installed-grounded wall outlet. Do not cut
or remove the third (ground) prong from
the power cord under any circumstances.
Any questions concerning power and/
or grounding should be directed toward a
certified electrician or an authorized products
service center.
6. This water dispenser is not recommended for
outdoor usage.
Water Dispenser / User Manual