Table of Contents
Advertisement
4
Cleaning and maintenance
4.1 Maintenance
1. Remove power plug or disconnect from the
mains before performing any maintenance or
servicing the product.
2. Never use detergent or chemicals harmful to
health to clean the water tanks.
3. Do not directly spray water on the surface of
the product.
4. Wipe the front and back of the product with
water-soaked soft cloth.
5. If dust of other exterior substance has
accumulated on the condenser, wipe off with
water-soaked soft cloth.
5
Installation instructions
In order to ensure the water dispenser with
enough stability, users should follow below
instructions to fix the unit:
1. Remove on the body rear's screw (upper right
corner or upper left corner) (Picture 1).
10 / 11 EN
6. After cleaning the product, completely dry it. Fill
the water to the tanks until waters comes out of
the hot water faucet, then connect the electric
power plug. If the surface of the electric heater
in the hot water tank is deposited by water
deposition, heating capacity will decrease. Fill
hot water tank with aqueous solution of 2%
aitric acid and keep for about two hours then
cleaning. If the problems can not be solved,
contact your dealer or the Service Center of
our company.
7. If power supply cord on this device is damaged,
it must be replaced with a special power supply
cord that is obtainable at Service Center of our
company
C
Never use gasoline, benzene or
similar substances for cleaning
purposes.
2. Install a bracket where you have removed
the screw already, fix the bracket
tightening this removed screw on the
right location (Picture 2).
3. Fix the bracket on the wall side or similer
object (if the wall side is too rigidity), you
can make a hole by electric drill, then
using expanded screw tightening the
bracket (Picture 3).
Water Dispenser / User Manual
Hide quick links:
Advertisement
Table of Contents
