1_Introduction; 2_Faults And Damages; 3_Further Safety Advice - DeWalt MD501 Quick Start Manual

4

1_INTRODUCTION

This document contains information and safety regulations
which are to be observed without fail for safe operation of
the smartphone D WALT MD501 under the described
E
conditions.
The current EC declaration of conformity, safety instructions
and manual can be found at www.D
or requested from Global Mobile Communications Ltd.
NOTE
This document contains only the instructions necessary
for setting up and safe use of your phone.
To ensure the IP protection of the phone, please make sure
that the USB port cover and all the screw covers are in
their correct place.
Please consult page 13 to learn how to access the phone
from any computer.
SAFETY INSTRUCTIONS TITEL DES KAPITELS
WALTPHONES.com,
E
SAFETY INSTRUCTIONS

2_FAULTS AND DAMAGES

If there is any reason to suspect that the safety of the phone has
been compromised, it must be withdrawn from use immediately.
Measures must be taken to prevent any accidental restarting
of the phone.
The safety of the phone may be compromised if, for example:
malfunctions occur.
the phone has been subjected to excessive loads.
the phone has been stored improperly.

3_FURTHER SAFETY ADVICE

Do not touch the screen of the phone with sharp objects.
Dust particles and dirt may scratch the screen. Please
maintain the screen clean. Remove dust on the screen with
a soft cloth gently and do not scratch the screen.
Charge the phone under indoor conditions only.
Please do not put the phone in environments with excessive
temperatures, as this could lead to excessive heating of the
battery, resulting in fire or explosion.
Do not charge the phone near any flammable or explosive
substances.
Do not charge the phone in environments with much dust,
humidity or excessively high or low temperatures
(the permitted charging temperature range is 5 °C – 35 °C).
Do not use the phone in areas where regulations or legislation
prohibit the use of a mobile phone.
Do not expose the phone, the battery or the charger to strong
5
EN