GE CV936 Owner's Manual And Installation Instructions page 12

Installation instructions
PARTS PROVIDED
Locate the har(h_are arcessor} box packed _dth tile
hood and check contents.
2 Aluminum
Grease Filters
Screws, wall
fasteners, washers
Duct
Transition
with Damper
Filter
Support
DUCT COVER REQUIREMENTS
We recommend that the vent hood and de(orative
duct cover (if used) be on site before final Kaming and
wall finishing. This will help to accurately locate studs,
ductwork and electrical service. Read these instructions
to determine if tile duct cover accessory can be used ibr
your installation situation.
Duct Cover Accessory:
* [)se tile decorative duct
cover to conceal ductwork
running fl'om tile top of
tile hood to tile ceiling.
* Tile duct cover accessory
consists of 2 pieces. Tile
outside piece is 12" high,
the inside piece is 22".
Nested together they are
24"rain., expanding to
a total maximum height
of 3 4 ':
* The outside piece can
be used alone to fill a
12 "h eight.
* Fox" heights over 12", tile
ceiling b*acket must be
installed to secm'e tile
cover at tile top,
To avoid unsightly gaps, plan the hood installation height
for duct cover use,
* The cover will fit a 12"rain. height fl'om tile top of tile
hood to tile ceiling,
- or 24"rain. and expanding up to 34"fl'om tile top of
the hood to tile ceiling.
THE DUCT COVER CANNOT BE USED WHEN THE
DISTANCE ABOVE THE TOP OF THE HOOD IS
BETWEEN 12 "AND 24",
P.exiew tile following examples to ensure a trouble free
installation usiw, tile duct cover accessory.
8ft. Ceilings: The hood must 8 ft• Ceiling
be installed at 30"above the _ I I I
• ,, 1F
cooklngsurface(or66 above _
I II
the floor)•The duct coverwill
II V
n0tfitiftheh00disinstalledat
II /
a lower or high,erheight. Use
II /
the outside 12 section, discard _ f
the inside section. _ /
30"
7 [ lr--
g ft• Ceiling
i7:
24" 30"
gfl. Ceilings: Install the hood 24"min. and up to a maximum of 30"
above the cooldng surface. The duct cover will expand to reach
ceiling height.
10ft. Ceiling
(
T 'L
32" 36" Max.
71 ]1- 7F 7F
10R. Ceilings: Install the hood 32"min. to 36"max. above the cooldng
sufface. The duct cover will expand to a maximum of 34"above the
top of the hood to meet the ceiling.
12