To Install Thermostat - GE RAK148F2 Owner's Manual And Installation Instructions

INSTALLATION INSTRUCTIONS

TO INSTALL THERMOSTAT

IMPORTANT:
conform to local and national building and electrical codes
and ordinances.
Note: Mount the thermostat about five feet above the
floor. Do not mount the thermostat on an outside wall,
in direct sunlight, behind a door or in an area affected by a
vent or duct.
1. Turn off power to the heating and cooling system
by removing the fuse or switching off the appropriate
circuit breaker.
2. Move the Function switch on the thermostat to Off.
3. Remove the cover by inserting and twisting a coin or
screwdriver in the slots on the top of the thermostat.
4. Put thermostat base against the wall where you plan
to mount it. Make sure wires will feed through the
wire opening in the base of the thermostat.
5. With the base level, mark the placement of the
mounting holes.
6. Set thermostat base and cover away from working
area.
7.
have marked for mounting.
8. Use a hammer to tap supplied anchors in mounting
holes.
9. Align thermostat base with mounting holes and feed
the control wires through the wire opening.
6
Thermostat installation must