1MRS757278
3.
3.1.
3.2.
COM600 series, Version 4.1
FDIR Configuration Manual
FDIR configuration
Building FDIR project on SAB600
To build an FDIR project on SAB600, you need to configure a proper communication
structure, single line diagram and use FDIR Configuration Tool to automatically generate
a Logic Processor FDIR project and cross-references.
When FDIR is used in COM600, the single line diagram rep-
resents only the FDIR network.
The FDIR single line diagram differs from the normal COM600 substation single line
diagram. The FDIR single line diagram currently only uses the Circuit Breaker symbol
to represent a switch, the Outfeeder symbol to represent load, and Infeeder and Busbar
symbols to represent source. Other symbols are not used in the FDIR single line diagram.
FDIR communication structure
The IEDs in the network need to be configured in the SAB600 communication structure.
For more information on the configuration, refer to the related communication protocol
configuration manual. Figure 3.2-1 shows an example of a typical IED configuration.
11