Cleaning The Humidifier - DR. Heater DR-998 Elite Series Owner's Manual

Cleaning the electrostatic
filter
The heater has an electrostatic filter
located at the rear. The filter should
be cleaned once per month or as
needed (when dust is visible on the
filter) to ensure efficient operation of
the heater.
1. Power the heater OFF by pressing
the POWER button located on the
left side of the Control Panel.
2. Unplug the heater's power cord.
3 Release the filter by pushing the
filter up from below (Figure 7).
4. Remove the filter by pulling down
and out (Figure 8).
5 Clean the filter by vacuuming.
6. Replace the filter by sliding the top
upwards into the spring-loaded slot
on the back of the heater
(Figure 8). Then gently push the
bottom of the filter into place
(Figure 7).
FIG 7 FIG 8

Cleaning the humidifier

The humidifier should be cleaned
once per month or as needed to
ensure efficient operation.
1. Power the heater OFF by pressing
the POWER button located on the
left side of the Control Panel.
2. Unplug the heater's power cord.
3. Press the two hooks in the rear of
the wooden box and push out the
humidifier.
4. Open the cover of the humidifier.
5. Clean the humidifier with water.
Warning!
Any other servicing
needed must be performed by an
authorized service representative. Do
not attempt to service the unit
yourself.
Product Specifications
Model#: DR-998
Voltage: 120V, 60Hz
Current: Maximum continuous draw:
12.5 amps
Output: 5200 BTUs
Power: 1500 Watts
Turbo Fan: Multi-blade; Low Noise