Table of Contents
Advertisement
When address <ADDR2> is smaller than that of <ADDK>, error message
is displayed.
G (Go)
G<CS:IP><OLD>[<ADDR>[,<BRK>]]<CR>
Execute the program
If=<CS:IP> is set execution hegins at the address specified to
execution start at address specified, enter <CR>, or to change
execution address, enter <ADDRESS> as specified, to set break
point, enter <CR> after <BRK> input.
following message BR@<CS:IP> displayed and returns to command.
I (Port Input)
I[W]<PORT><CR/,>
When contents of designated port are displayed, then enter
<CR/,>.
When comma is entered, contents of the same port is
displayed at a time difference of same displayed port.
N (Single Step)
N<CS:IPXOLD>[ <ADDR> ] <CR/, >
Contents of designated CS and IP are displayed in hexadecimal
and with four digits.
To change the address of the program execution, enter <ADDR>
with its entry, and next instruction CS and IP is displayed
after current instruction has been executed.
0 (Port Output)
<PORT>
0[W ]
,<NEW><CR/,>
Data set at designated port.
When <BRK> is designated,
Enter <CR/,> to execute single step.
If comma is entered,
7-19
Advertisement
Table of Contents
