Table of Contents
Advertisement
Fuse
Capacity
No.
(A)
(1)
30
CRS system fuel pump
(2)
20
SCR system
(3)
30
SCR heater system
(4)
10
Nox sensor, SCR tank sensor
(5)
10
EGR valve air flow sensor
(6)
20
Spare fuse
(7)
30
Spare fuse
[Oil separator Fuse] (if equipped)
Fuse
Capacity
No.
(A)
(1)
15
Heater (Oil separator, OUT 1)
(2)
15
Heater (Oil separator, IN)
(3)
15
Heater (Oil separator, OUT 2)
Protected circuit
Protected circuit
BReplacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them has blown out, be sure to pinpoint
the cause. Never use any substitute, use only a KUBOTA
genuine part.
No.
Capacity
Protected circuit
1
100A
Charge
2
50A
SCR system
3
50A
Head lamp
4
30A
Key switch
5
120A
Engine preheat
6
60A
Front work light
7
30A
Rear work light
PERIODIC SERVICE
Type
Bolt fixed
Non Bolt
fixed
Bolt fixed
Non Bolt
fixed
111
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the M5L-111 and is the answer not in the manual?
Questions and answers
What is a regen looking symbol on left side of screen is on but goes off in a couple of seconds or when you push clutch in?
Why would engine oil pressure drop with adequate level showing on the dip stick?
If the engine oil pressure drops in a Kubota M5L-111 despite an adequate level on the dipstick, possible reasons could include:
1. Oil pump malfunction.
2. Clogged oil filter.
3. Use of incorrect oil type or viscosity.
4. Internal engine wear causing increased clearances.
5. Faulty oil pressure sensor or gauge.
These issues can reduce oil flow or cause inaccurate pressure readings even if oil level is correct.
This answer is automatically generated