Table of Contents
Advertisement
100
PERIODIC SERVICE
BReplacing Hydraulic Oil Filter
C Cleaning Magnetic Filter
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the drain plug at the bottom of the
transmission case and drain the oil completely into an
oil pan.
2. After draining reinstall the drain plug.
(1) Drain plug
3. Remove the 2 oil filters.
4. Wipe off metal filings from the magnetic filter with a
clean rag.
(1) Hydraulic oil filter
(2) Magnetic filter (Wipe off metal filings)
5. Put a film of clean transmission oil on the rubber seal
of the new filters.
6. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
7. After the new filters have been replaced, fill the
transmission oil up to the upper notch on the dipstick.
(1) Gauge
(A) Oil level is acceptable within this range.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak pass
the seal on the filter.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the M5L-111 and is the answer not in the manual?
Questions and answers
What is a regen looking symbol on left side of screen is on but goes off in a couple of seconds or when you push clutch in?
Why would engine oil pressure drop with adequate level showing on the dip stick?
If the engine oil pressure drops in a Kubota M5L-111 despite an adequate level on the dipstick, possible reasons could include:
1. Oil pump malfunction.
2. Clogged oil filter.
3. Use of incorrect oil type or viscosity.
4. Internal engine wear causing increased clearances.
5. Faulty oil pressure sensor or gauge.
These issues can reduce oil flow or cause inaccurate pressure readings even if oil level is correct.
This answer is automatically generated