Remote Operation; Remote Operation; Basic Operation - Sanyo sfx-32 Instruction Manual

47
Remote operation
You can access the built-in TAS of SFX-32 remotely using touch-tone tele-
phone.
The SFX-32 needs to be set to ANSWER mode, no the other modes (AUTO/
MANUAL) can be accessed remotely.
1
E
@@@
Dial to the SFX-32.
@@@
@@@
@@@
2
E
@@@
Enter the 4-digit personal l/D number
while OGM is released or within 9 see-
@@@
ends after the OGM is finished.
@@@
YOU hear
a beep for an acceptance.
A touch-tone telephone which gen-
@@@
crates DTMF signal is required for
entering the 4-digit personal 1/D.
3
El
@@@
Enter your desired remote code (see
remote code table).
@@@
YOU hear
a beep for an acceptance.
@@@
A touch-tone telephone which gen-
erates DTMF signal is required for
@@@
entering the remote code.
4
Hang up the handset when you finish the
operation.
9 When you make a mistake in entering the 4-digit I/D, four times of short beep
can be heard.
Enter the correct number again within 10 seconds after the beep.
When you make a mistake in entering the remote code, one beep can be
heard.
Enter the correct number again within 10 seconds after the beep.
When you enter the personal l/D number, enter the first digit and confirm the
OGM is stopped, then enter the following three digits. If the OGM is not stop-
ped, repeat entering the first digit until it is stopped.