Siemens SINUMERIK 828D Operating Manual page 451

Parameter Description
ER Radius of helix - (only for helical insertion)
The radius must not be larger than the milling cutter radius, otherwise material will
remain. Also make sure the circular pocket is not violated.
Solid machining
Complete machining
•
The circular pocket must be milled from a solid workpiece (e.g. casting).
(only for G code)
Post machining
•
A small pocket or hole has already been machined in the workpiece, which needs
to be enlarged. Parameters AZ, and ∅1 must be programmed.
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
AZ Depth of premachining - (for remachining only)
(only for G code)
∅1 Diameter of premachining - (for remachining only)
(only for G code)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter Description
Machining
•
surface (only for
•
ShopTurn)
•
•
Position (only for
•
ShopTurn)
•
•
•
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
simple
•
mm
*
Face C
Face Y
Peripheral surface C
Peripheral surface Y
At the front (face)
At the rear (face)
Outside (peripheral surface)
Inside (peripheral surface)
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
9.4 Milling
Unit
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
451