Setting The Real-Time Clock - ADEMCO Vista-15 Installation And Setup Manual

VISTA-15/VISTA-15CN Installation and Setup Guide

Setting the Real-Time Clock

General Information
This system provides a real-time clock that must be set in order for the system's event log to
keep track of events by time and date.
Setting the Time and Date
1. Enter [4-digit Installer or Master code] + [#[ + [6] + [3[.
2. Press the [ ] key to change the Date/Time setting. The display reverts to the following:
3. The blinking cursor appears on the first digit of the hour to begin. Enter the time (hour,
4. Press any odd-digit key for PM, or any even-digit key for AM.
5. Enter the 4-digit year, the 2-digit month, and the 2-digit date, in sequence. The day of
6. Look over the display to make sure it is correct. To change incorrect information, press
7. Press the [ ] key until the cursor is at the far right position.
8. To accept all of the clock information, press the [ ] key again. The top display appears.
9. Exit clock mode by pressing the [#] key.
22–6
www.PDF-Zoo.com
• Use a 6139 Alpha Keypad to set the real-time clock, or set the clock via the downloader
software.
• Only users with Installer or Master authority level can set the real-time clock.
• In the event that both sources of power (AC and Battery backup) are lost, it is necessary to
reprogram the Real Time Clock.
The alpha keypad indicates the following:
TIME/DATE
12: 00AM 01/01/99
The above display disappears in one minute if no entries are made or if the [#] key is
pressed. If this happens and you still want to make changes, repeat step 1.
TIME/DATE
12: 00A1999/01/01
then minute). After each entry, the cursor moves to the right.
the week is automatically calculated and displayed based on the date entered.
the [#] key, which moves the cursor one space to the left, until the cursor sits on the
improper entry. Then press the correct key(s).
FRI
FRI