Kenwood KDC-138 Service Manual page 17

• K3I forced switching
Every time when [6] key is pressed in tuner FM source, switched in the following order: AUTO → Forced WIDE → Forced MIDDLE → Forced
NARROW → AUTO. Default status is AUTO, and displayed as shown below.
Key
6 K3I Forced switching
• RDS auto measurement (Only for model with RDS)
Add the process to replace the visual inspection of PS display previously done in the production line.
Status
PS data reception
• FST adjustment mode
Perform FST soft-mute adjustment.
Key
Enter the FST adjustment mode. (Press for 1 second or longer.)
■
Operations in the FST adjustment mode are as follows:
Key
/
Soft-mute adjustment
Seek Stop Level
adjustment (Auto)
FM
(UP) Seek Stop Level
AM adjustment (Auto)
(DOWN)
/ Seek Stop Level
adjustment (Manual)
/ Seek Stop Level
adjustment (Manual)
Adjustment value
■
memory
Mode clear
Switch Local Seek ON or OFF by briefl y pressing [AUTO]/[TI] key when the Local Seek ON/OFF switching is allowed in the band.
After completing the FST adjustment, if you wish to clear the test mode, you can do this using the reset button.
TEST MODE (14-SEG VFD)
Description of display
F M 1 9 8 . 1
F M 1 9 8 . 1
F M 1 9 8 . 1
F M 1 9 8 . 1
Display
R D S T E
Description of display
S M D – F
A T N
A T L
M N N
M N L
E P W R
F M 1 9
AUTO
A
Forced WIDE
W
Forced MIDDLE
M
Forced NARROW
N
If displayed as shown at the left, force to OFF.
S T
P-CON is recovered by Power OFF/ON.
Note
0 ↔ 7
0.00 (V) ↔ 5.00 (V). Normal (Local OFF)
V
0.00 (V) ↔ 5.00 (V). Normal (Local ON)
V
0.00 (V) ↔ 5.00 (V). Normal (Local OFF)
V
0.00 (V) ↔ 5.00 (V). Normal (Local ON)
V
Displays the data that has been written in the E2PROM
I T E
when pressing the key for 2 seconds or longer.
Clear the FST adjustment mode. (Returns to normal
8 . 3 A 4
display and the test mode is retained.)
X34-56xx-xx
Description
Description
Description
17