Teeter Hang Ups F5000 Assembly Instructions

ASSEMBLY INSTRUCTIONS

PRE-ASSEMBLY

Before you begin: These instructions will guide you in properly assembling the unit. Please review all the steps before beginning assembly.
Carefully adhere to the Assembly Instructions and Owner's Manual to help ensure user safety and product integrity.
1. It is your responsibility to familiarize yourself with the proper use of the equipment and the inherent risks of inversion, such as falling on your
head or neck, pinching, entrapment or equipment failure.
2. This product is not designed for persons over 6'6" (198 cm) or 300 lbs (136 kg). Structural failure could occur or head/neck may impact floor
during inversion. Serious injury or death could result.
3. DO NOT use the equipment without a licensed physician's approval and a review of the medical contraindications, as noted in the Owner's Manual.
4. Failure to assemble and/or use the equipment as directed may void the manufacturer's warranty on this product and could result in injury or death.
5. DO NOT use the inversion table until you have thoroughly and carefully read the Owner's Manual, viewed the Instructional Video, reviewed all
other accompanying documents, and inspected the equipment.
6. The steps in the video directly coincide with the steps detailed in these Assembly Instructions.
7. Choose a level surface for assembling and operating the table.
8. Follow each step in sequence. Do not skip ahead.
9. Make sure that all fasteners are secure.
10. PRIOR TO USE, test and inspect the table. Make sure the table rotates smoothly to inverted position and back.
Carefully remove the individual parts from the carton. You should have all of the items listed below. If any items are missing or damaged, contact
your retailer or customer service directly (See Pg. 4).
ITEMS FOR ASSEMBLY
A-frame base
Main shaft w/ front ankle clamp
Table frame with mat
Hand grips (2) and
1/2" hex bolts (6)
(13mm)
Two (2) roller hinges
Two (2) wrenches
Rear bar with ankle clamps
2" Hex Bolt / Nut / Washer F51087
(51mm)
Black Rubber Plug
Triangle-head knob
Foot platform

ASSEMBLY

STEP ONE
Assemble the A-frame Base (F51002)
• Open the A-frame and make sure that the spreader arms are locked flat.
(See Figure 1)
Figure 2
(R)
TM
F5000
&
TM
F6000
!
ITEM #'s
F51002
F51039
F51021
(F5000)
F61021
(F6000)
F51069
H11202
F51064
F51088
F51052
F51056
F51063
F51060
NOTE: Bolts may be
packaged separately
or assembled in
hand grips.
STEP TWO
Install Hand Grips (F51069) on A-frame Base (F51002)
• Place one of each hand grip (left / right) over the outside edge of the corre-
sponding hinge plate. (See Figure 2)
(L)
• Insert three 1/2" (13 mm) hex bolts (H11202) through the hinge plate into each
hand grip. Use the wrenches provided to tighten the bolts, being careful not to
over tighten.
DO NOT DISCARD - KEEP FOR FUTURE REFERENCE.
U.S. and foreign patents apply. Other foreign patents pending.
WARNING
F51002
F51021
(F5000)
F61021
(F6000)
F51039
F51056
Spreader Arms
H11202
Bolts may be
p a c k a g e d
separately or
a s s e m b l e d i n
hand grips.
F51069
F51088
F51064
F51052
F51087
F51060
F51063
Figure 1