Changing The Operating Mode - DAITEM SH511AX Installation Manual

1.3 Operating mode
1.3.1 The dialler has 3 separate operating modes:
• installation mode for dialler installation and maintenance,
• test mode for dialler functional testing,
• user mode for dialler daily use.
1.3.2 The dialler's different functions and commands are protected by 3 separate access codes:
• 1 MASTER code, to be used by the main system user in USER mode for:
- activating all of the dialler's commands locally via the dialler keypad (full dialler use),
- remotely accessing the dialler via a PC (and via Smartphone and touch-screen tablet applications: iPhone/iPad and
Androïd),
- operating the system remotely over the phone (for incoming calls via the GSM network, the product must be connected
to the mains).
• 1 INSTALLER code, to be used by the installer in INSTALLATION mode for:
- completely accessing the dialler during installation on site via the dialler keypad or a PC with TwinLoad
which is linked to the radio configuration tool (in this case the dialler is configured by radio via the control panel),
- remotely accessing the dialler via a PC with TwinLoad
the user's rights defined when parameter 611 is programmed.
• 1 VIDEO code, to be used mostly by the user and which provides secure access to video footage via the Internet.

Changing the operating mode:

The operating mode is changed using the factory master code "0000" then the factory installer code "1111" as shown
below:
INSTALLATION
MODE
2 flashes
every 10 s
Factory:
• installer code "1111"
• master code "0000"
• video code "4444"
IMPORTANT
• For security reasons, the keypad automatically switches back to user mode after 4 hours without a command being
issued.
• If 5 wrong codes are entered in less than 5 minutes the keypad will be blocked for 5 minutes and notification that a wrong
code has been entered will be issued.
• The request to change system operating mode issued by the dialler is only taken into account when the control panel
issues a voice message about the new system status in order to validate the change.
Example: switching from test mode to installation mode:
installer code
• - To check the dialler's operating mode at any time, use the keypad to enter:
- in installation (or test) mode:
"bip, system status,
installation (or test) mode,..."
installer code
"bip, installation mode"
DIALLER
DIALLER
software. This is possible in all modes (factory: TEST), subject to
®
TEST MODE
1 flash every 5 s
"bip, installation mode"
CONTROL PANEL
- in user mode when the system is disarmed (or armed):
master code
5
® software and
USER MODE
"bip, systemc status,
off (or armed), ..."
DIALLER