Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DAITEM SH401AX
Summary of Contents for DAITEM SH401AX
-
Page 2: Preparing The Siren
• The operating differences with former ranges are described in the compatibility booklet available in the Daitem installers section at www.daitem.co.uk. In addition to the protection provided by the control panel with built-in siren and keypad, the indoor siren deters intruders. -
Page 3: Recognition Programming
4. Setting the parameters IMPORTANT: all parameter-setting must be done using TwinLoad ® software available in the Daitem installers section at www.daitem.co.uk. The control panel and siren must be in installation mode to set the siren’s parameters. If they are not, enter:... - Page 4 4.3 Sound level of arm and disarm command indications For greater user-friendliness, the sound level can be increased or decreased. To do this, enter: siren n° from 1 to 8 Factory setting: 4 = average 4.4 Transfer of arm and disarm commands To change the transfer of indications, enter: siren n°...
-
Page 5: Radio Tamper
4.10 Radio tamper If the radio links are deliberately tampered with, the siren is triggered. To activate or deactivate the radio tamper system, enter: siren n° 0: disabled 1: enabled Factory setting: 1 4.11 Allocation of siren to alarm group To allocate the siren to one or several alarm system groups, Example: to allocate siren n°... -
Page 6: Performing A Real Test
5.3 Fixing the siren in place 1. Remove the tamper mechanism washer 2. • For the siren to be installed there must be a space of 6 cm to the located on the back of the siren. left of the base, 4 cm above and 18 cm below. This clearance allows for the siren to be easily opened or locked. -
Page 7: Maintenance
• The lithium battery pack must be replaced by the same type of pack with the same technical characteristics, i.e. 2 x (3.6 V – 13 Ah). • We advise you to use the DAITEM BatLi22 pack available in the catalogue in order to guarantee individual safety and equipment reliability. -
Page 8: Technical Data
Research & Development Manager Non-binding document, subject to modification without notice. To obtain advice when installing your system or before returning equipment, please contact the Daitem technical support team (see telephone number at the back of the alarm system installation manual)
Need help?
Do you have a question about the SH401AX and is the answer not in the manual?
Questions and answers