Mitsubishi Electric 738 Series Owner's Manual page 71

Setting Up A/V Receiver Control, continued
Before You Begin
To complete these steps you will need:
• The remote controls for both the TV and the
A/V receiver.
• An IR emitter cable available from Mitsubishi.
• An HDMI-to-HDMI cable to connect the A/V
receiver to the TV and cables necessary to
connect devices to the A/V receiver.
1.
Connect the A/V receiver to the TV with an HDMI-
to-HDMI cable. Do not connect the optional audio
cable at this time.
2.
If desired, enable HDMI Control of a CEC-enabled
A/V receiver. See Appendix C, "HDMI Control of
CEC Devices" on
3.
Connect your audio/video devices to the A/V
receiver. Note the name of the device connected
HDMI
2
1
TV
HDMI cable
A/V receiver with
HDMI output
Any connection
types
High-definition
DVD player
Multiple video inputs through a single HDMI cable. The
optional audio connection allows you to hear, through the
A/V receiver, devices connected to the TV only, e.g., an
antenna on the ANT input.
Downloaded From TV-Manual.com Manuals
6. NetCommand Control of an A/V Receiver (838 Series)
page 83.
DIGITAL DIGITAL
DVI/PC AUDIO AUDIO
AUDIO AUDIO
R INPUT L R OUTPUT L
OUTPUT OUTPUT
Y/ VIDEO Pb Pr
DIGITAL R
LAN
AUDIO
3
OUTPUT
Y/ VIDEO Pb Pr
R AUDIO L (480i / 480p / 720p / 1080i)
Optional
analog or
digital audio
connection
HDMI OUT
DIGITAL
AUDIO IN
ANALOG AUDIO IN
DVD player
Cable box
to each A/V receiver input. This information will be
needed later to set up NetCommand's automatic
input switching.
4.
If using an optional audio cable between the TV
and A/V receiver, connect it. Set up NetCommand
control of the A/V receiver's TV audio input when
setting up automatic switching in the next procedure.
5.
Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See
Setup to Control Automatic Audio
and Video Switching via HDMI
When this setup is complete, the "learned" A/V receiver
input will appear in the TV's Input Selection menu as a
selectable input.
1.
Set the
2.
Navigate to the
ANT
AUDIO
3D
GLASSES L
OUTPUT
EMITTER
To set up A/V switching over HDMI, choose your A/V
receiver input from a list.
3.
In the
A/V receiver input to control. In this example, it is
the DVD input.
4.
Press
5.
While the text
R L
DVD INPUT key on the A/V receiver's remote control.
6.
When a check appears next to
DVD INPUT key.
VCR
•
•
7.
If using an optional audio cable between the TV and
A/V receiver, "learn" the TV AUDIO OUT key to enable
automatic switching of audio from sources con-
nected to the TV only.
8.
If there are no more devices to set up, highlight
EXIT and press ENTER or continue to set up addi-
tional A/V receiver audio/video sources.
"IR Emitters," page
TV's remote control to TV mode.
Inputs > AVR menu.
Inputs > AVR menu, highlight the name of the
ENTER on the TV's remote control.
DVD is flashing, press and hold the
If the text stops flashing before the check mark
appears, repeat this step.
To erase the IR code just "learned," press
CANCEL while the name is highlighted.
Y/ VIDEO
For assistance call 1(800) 332-2119
71
63.
DVD, release the