Table of Contents
Advertisement
Setting Up A/V Receiver Control
Power and Volume
Perform this setup to control A/V receiver power and
volume with the TV's remote control.
To perform this setup you need:
•
The remote controls for both the TV and the
A/V receiver.
•
An IR emitter cable available from Mitsubishi.
Before You Begin
1.
Connect your A/V receiver to the TV and any addi-
tional devices.
2.
Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See
3.
Set the
TV's remote control to TV mode.
Setup to Control A/V Receiver Power and Volume
1.
Inputs > AVR menu.
Open the
2.
The first function highlighted in the
always Power. Aim the TV's remote control at the
TV and press ENTER to begin learning for Power.
Inputs > AVR screen. Perform
NetCommand IR "learning" for A/V
receiver power and volume keys.
Downloaded From TV-Manual.com Manuals
6. NetCommand Control of an A/V Receiver (838 Series)
"IR Emitters," page
63.
AVR screen is
3.
When the
Power text starts flashing, aim the A/V
receiver's remote control at the TV and hold the
POWER or POWER ON key until a check mark appears
next to Power.
•
If the text stops flashing before the check mark
appears, repeat this step.
•
To remove the key from NetCommand control,
press the CANCEL key while the key name is
highlighted.
4.
key on the TV's remote control to highlight
Press the
other keys in the list. Repeat steps 2 and 3 for each
additional function you wish to control through NetCom-
mand.
5.
If the A/V receiver has a separate
press
on the TV's remote to highlight Power
Off. Repeat steps 2 and 3 to "learn" the POWER OFF
key. If the device has no POWER OFF key, skip this
step.
6.
When finished "learning" the power and volume
keys, press EXIT to watch TV or continue
NetCommand setup if using an HDMI connection.
See
"Automatic Audio/Video Switching Over an
HDMI Connection" on the next page
For assistance call 1(800) 332-2119
69
POWER OFF key,
Advertisement
Table of Contents
Troubleshooting
