Update Firmware; On Board Preferences - Flashforge FINDER User Manual

2.9.3 Update Firmware

Every time when you start the software, it will automatically detected the
update and download new printer firmware. If there is new available
firmware, it will remind user to update, the installation method is as
below:
Step 1: Click [Tools]--[Update firmware]. It needs to cut off connection
before updating firmware. If software and printer are already in
connection, it reminds you cutting off the connection, choose [Yes] and
go on to the next step.
Step 2: Choose corresponding printer type and firmware version and
click [OK] in the firmware updating box. After confirming the printer is
in free state, the software will automatically update the firmware.

2.9.4 On Board Preferences

When the computer and printer are in connection state, click [Tools]--[On
Board Preferences], you can check the printer name, extruder quantity
etc.
Finder User Guide| www.ff3dp.com