Siemens INOX PRO SIMATIC IPC277D Service Manual page 22

Extended maintenance work
4.6 Fastening the rear panel
Procedure
1. Make sure that the seal is flush with the rear panel and does not protrude between rear
panel and front.
2. Screw in the four screws in the corners of the rear panel about halfway as shown in the
figure below.
3. If necessary, correct the position of the rear panel.
4. Screw in all 20 screws of the rear panel completely.
5. Tighten the screws with a torque of 3.5 Nm.
22
SIMATIC IPC277D 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 03/2015, A5E35751762-AA