GE Moisture monitor series 3 Programming Manual page 20

March 2008
Displaying
Measurements (cont.)
2-4
Table 2-1: Measurement Modes
Display Abbreviation
O
H
T
P
AUX1
AUX2
USER*
VREF
GND
*User functions are available only through PanaView
software. For more information, refer to Chapter 4.
When selecting a measurement mode, please remember that some
measurement modes require multiple inputs. For example, to display
ppm , you need a moisture and pressure input. Table 2-2 below shows
v
a list of measurement modes that require multiple inputs and what
you need to display them. If the MMS-3 displays "No Data," you may
have to reconfigure the channel. Refer to Reconfiguring a Channel
for a New Sensor on page 3-35.
Table 2-2: Measurement Modes and Required Inputs
To measure:
RH
PPM
v
PPM
w
PPB
v
MCF/IG
MCF/NG
PPM /NG
v
.
Select HYGRO Unit
[DP/°C] DP/ °F
Repeat this procedure to set up the other line. When you are done,
[RUN]
press .
Measurement Mode
Oxygen
Hygrometry
Temperature
Pressure
Auxiliary 1
Auxiliary 2
User Function
Volt Reference
Signal Ground
You need the following inputs:
Temperature and moisture
Moisture and pressure
Moisture, temperature and
saturation constant data
Moisture and pressure
Moisture and pressure
Moisture and pressure
Moisture and pressure
L1
Use the arrow keys to move the
brackets to the measurement
units and press
[YES]
.
Basic Programming