Panasonic BB-HCS301A Getting Started Manual page 4

Setting up this product Using the MAC Address on the Setup Program
The Setup Program may not list this product due to your firewall or
antivirus software settings on your PC. If you cannot disable your
firewall or antivirus software, you can set up this product using this
product MAC address as shown below.
Enter this product's MAC address in the data field,
and click [Set up camera].
Note
This product's MAC address can be found on the sticker affixed to the bottom
of this product (see page 11 of the Operating Instructions on the Setup CD-
ROM for details).
After confirming the network settings, click [OK].
• After about a minute, the Security: Administrator page is displayed.
Enter the user name and password, and click [Save].
Security Warning window on Microsoft Windows XP Service Pack 2
To view a video (Motion JPEG) or to listen to audio feature, ActiveX Controls must be installed.
Follow the steps shown below to install ActiveX Controls.
Click the warning displayed above the tabs, and click [Install
ActiveX Control...].
Example of connection
Analog Camera
Microphone
(Local Audio)
Enter the MAC address.
Amplifier or
mixer
Network
Enter the user name and password that you set, and click [OK].
When the Single Camera page is displayed, the setup
is completed.
• If the Security Warning window is displayed to install ActiveX Controls,
click [Yes].
• To install ActiveX Controls on Microsoft Windows XP Service Pack 2, see
"Security Warning window on Microsoft Windows XP Service Pack 2"
below.
Allow the Internet access to this product.
• When you are using a router supporting UPnP
1. Enable the Auto Port Forwarding feature on the UPnP
55 of the Operating Instructions on the Setup CD-ROM).
2. Register with the DynamicDNS service on the DynamicDNS page (see
page 58 of the Operating Instructions on the Setup CD-ROM).
3. Confirm the Internet access to this product (see page 12 of the Operating
Instructions on the Setup CD-ROM).
Note
If you cannot access this product, see page 7, 8 and 9 in the
Troubleshooting on the Setup CD-ROM.
• When you are using a router not supporting UPnP
Follow the procedures shown on page 57 of the Operating Instructions on the
Setup CD-ROM.
Click [Install].
Amplifier
IN IN VIDEO VIDEO OUT OUT
I/O AUDIO UDIO
IN IN OUT OUT
IN OUT OUT
12 12 V
Note
• See page 16 of the Operating Instructions on
the Setup CD-ROM for the Single Camera
page.
• If you enable Internet access to this product,
follow the procedures below.
TM
TM
Monitor
Speaker
Speaker
TM page (see page
Microphone
(Remote Audio)